ProTeam 107128 Installation Guide download pdf (Page 2)

8 ProTeam

FILTER ASSEMBLY/REPLACEMENT (cont.)

Removal and Installation of Qwik Lock™ Fine Dust Cartridge Filter

Filter Removal:

1. Hold the filter tabs of the Qwik Lock

filter in each hand (Figure D).

2. With one thumb on the Qwik Lock

stud, which protrudes through the

integrated filter plate, lift up on

the filter tabs while pushing down

on the stud.

3. This action will cause the filter to

release from the filter cage. Slide

filter off cage.

Filter Installation:

1. Carefully slide the Qwik Lock filter

over the filter cage and press down

on the outside edge of the filter until

the rubber gasket on the bottom of

the filter seats securely around the

base of the filter cage and against

the lid.

2. Align the small center hole in the top of the filter over the Qwik Lock™ stud on

the filter cage. Press firmly on top of the filter near the stud to allow the filter

to snap over the ball on the end of the stud. The filter is now attached.

NOTE: Failure to properly seat the bottom gasket could result in debris bypassing

the filter.

Rubber

Gasket at

Bottom of

Filter

(cutaway

view)

Filter

Cage

Filter

Tabs (2)

Integrated Filter

Plate with Center

Hole

PUSH

DOWN

PULL

Qwik Lock™

Stud

Figure D

WARNING: Do not operate without filter cage and float, as they prevent liquid

from entering the impeller and damaging the motor.

IMPORTANT: To avoid damage to the blower wheel, always reinstall the filter

before using the Vacuum for dry material pick-up.

SP6768-3 PROTEAM 4 GALLON 10/22/12 7:01 PM Page 8

1 2

Figure D 2

Comments to this Manuals

No comments

ProTeam 107128 Installation Guide Page 2

Comments to this Manuals